Sensor WiFi Connect

The Sensor WiFi Connect app allows the user to easily perform the Wi-Fi connection settings of the Informetis' Smart Sensor using a smartphone.

By connecting the smart sensor to your home Wi-Fi (WLAN) network, you will be able to monitor the energy usage status of your home via a dedicated app.
(The dedicated app differs depending on the company that installed the smart sensor. Please contact your installer for more information)

Wi-Fi connection settings can be configured from the app when the corresponding smart sensor is in the following states.
・If you have never configured Wi-Fi settings
・If you were able to connect once, but the connection was lost due to reasons such as replacing your Wi-Fi router.

This app can be used by people who have Informetis' power sensor "Circuit Meter CM-3/J" or "Circuit Meter CM-3/EU" installed in their homes, and by approved installers who install the smart sensor.
*Please note that it is not compatible with CM-2/J, CM-2/UK or CM-2/EU.

[Notes]
- The smart sensor may not be found immediately after turning on the power or performing a reset operation. Please start Wi-Fi setting process 3 minutes after power up.
・If you have already connected your iOS smartphone to the smart sensor, please perform the following steps and then configure the Wi-Fi connection settings again.
[Operation] Unregister "WiFiInt" from the device list on the Bluetooth settings screen
-The smart sensor only supports Wi-Fi in the 2.4GHz band. (It varies depending on the model, but in the case of xxxx-g and xxxx-a, please use xxxx-g.)